Installation Guides

RockPanel

• Table – Use this to plan out your job.
• Pencil – To mark before cutting and gluing your panel.
• Carpenters Square – To ensure that you rule straight lines before you cut.
• Tape Measure – Remember the golden rule … Measure twice, cut once!
• Drill & Hole Cutting Bit – Use this to cut holes for your taps and shower fittings.
• Caulking Gun – To apply the silicone and panel glue.
• Wall Board Adhesive – We recommend Holdfast Fixall 220 MS.
• Spirit Level – To ensure that the sheets line up correctly. It is important that all sheets are installed level.
• Screws – General screw – S/S for outside, expanded screw dynabolts.
• Bog – Standard builders bog or weatherproof filler.
• Skillsaw/Jigsaw/Stanley Knife
• Fine Toothed Saw – Cut the panels FACE UP. Keep angle of saw less than 30 degrees to the sheet.

WetWall

• Table – Use this to plan out your job.
• Pencil – To mark before cutting and gluing your panel.
• Carpenters Square – To ensure that you rule straight lines before you cut.
• Tape Measure – Remember the golden rule … Measure twice, cut once!
• Drill & Hole Cutting Bit – Use this to cut holes for your taps and shower fittings.
• Caulking Gun – To apply the silicone and panel glue.
• Wall Board Adhesive – Holdfast Fixall MS220 and VHB Tape.
• Spirit Level – To ensure that the sheets line up correctly. It is important that all sheets are installed level.
• Silicone – Use only 100% silicone and ensure that it is designed for use in a Bathroom or Kitchen. We recommend GORILLA® Kitchen & Bathroom for exposed joins.
• Masking Tape – To protect your panels and ensure a clean finish when applying silicone.
• Fine Toothed Saw – Cut the panels FACE UP. Keep angle of saw less than 30 degrees to the sheet.

Need touch-up paint for your RockWall panels?

Download our Wattyl Solagard paint recommendations here.